jepac
2011-10-03, 06:54 AM
Welcome to use McnBox!
Selected COM5 COM3
Baud setting ...
Set Baud done
Initialize in progress ...
Checking data ...
Serial No. MCN20110xxxxxxx
Firmware V1.13
Checksum EE43-DBBE
Box Connected!
Ready working at COM5
Finder Testing ...OK
PWL Testing ...
11: Low volt get errorl
Chip Testing ...OK
Clamps Testing ...OK
Test Finished!
ask for an explanation with an error message during a test box and have a solution thanks
Selected COM5 COM3
Baud setting ...
Set Baud done
Initialize in progress ...
Checking data ...
Serial No. MCN20110xxxxxxx
Firmware V1.13
Checksum EE43-DBBE
Box Connected!
Ready working at COM5
Finder Testing ...OK
PWL Testing ...
11: Low volt get errorl
Chip Testing ...OK
Clamps Testing ...OK
Test Finished!
ask for an explanation with an error message during a test box and have a solution thanks